Jet geared head engine lathe - 12 speeds - 13" x 40" model- gh-1340w-3 User Guide
9
Lubrication
Lathe must be serviced at all
lubrication points and all reservoirs filled to
operating level before the lathe is put into
service. Failure to comply may cause serious
damage to the lathe.
operating level before the lathe is put into
service. Failure to comply may cause serious
damage to the lathe.
1. Headstock - Oil must be up to indicator
mark in oil sight glass (A, Fig. 4). Top off
with Mobil DTE
with Mobil DTE
Oil Heavy Medium. Fill by
pulling plug (D, Fig. 4). To drain, remove
drain plug (A, Fig. 5) with an 8mm hex
wrench. Drain oil completely and refill after
the first month of operation. Clean out any
metal shavings. Then, change oil in the
headstock annually.
drain plug (A, Fig. 5) with an 8mm hex
wrench. Drain oil completely and refill after
the first month of operation. Clean out any
metal shavings. Then, change oil in the
headstock annually.
2. Gearbox - Oil must be up to indicator mark
in oil sight glass (B, Fig. 4). Top off with
Mobil DTE
Mobil DTE
Oil Heavy Medium. Fill by lifting
off thread chart cover (E, Fig. 4) and remove
plug (C, Fig. 4) with an 8mm hex wrench.
To drain, remove drain plug (A, Fig. 6) with
an 8mm hex wrench. Drain oil completely
and refill after the first month of operation.
Then, change oil in the Gearbox annually.
plug (C, Fig. 4) with an 8mm hex wrench.
To drain, remove drain plug (A, Fig. 6) with
an 8mm hex wrench. Drain oil completely
and refill after the first month of operation.
Then, change oil in the Gearbox annually.
Figure 4
Figure 5
Figure 6