Jet jj-6csdx User Manual

 

10

Referring to Figure 3: 

1.  Take the lock handle (E), flat washer (F), and 

lock nut (G) from the carton

.

 

2.  Place the fence assembly (A) onto the table 

(B). Be sure the key stock (D) on the bed lines 
up with the channel (C) in the fence casting. 

3.  Place the flat washer (F) on hole (H)*; insert 

the lock handle (E) through the fence casting 
and the table casting. 

4.  Thread the lock nut (G) onto the lock handle 

(E). Make sure the tab on the nut faces up and 
engages the slot in the table casting. 

*Note: For rabbeting operations use hole (J). 

 

 

 

 

Referring to Figure 4: 

1.  Place V-belt (A) onto cutterhead pulley (B) and 

through opening in stand. 

2. Pull V-belt down and place onto motor 

pulley (C). 

Note: If the belt is difficult to roll on the pulley, 
loosen the motor mounting screws. 

3.  Check to make sure that motor pulley and 

cutterhead pulley are vertically aligned and the 
V-belt does not contact the sides of the 
opening in the base.  If the pulleys are not 
aligned, remove belt and adjust the motor 
pulley in or out on the motor shaft and then re-
attach the belt. 

 

 

 

 

4.  The V-belt is properly tensioned when finger 

pressure on the belt half way between the two 
pulleys causes 1/2" deflection (Figure 5).  If the 
belt is too loose, loosen the four motor mount 
bolts, push down on the motor to tension the V-
belt, and tighten the mounting bolts. 

5.  After two hours of operation, check belt tension 

again. Readjust the tension if necessary.