IQinVision IQA15 Installation Instruction

2.  Lift open the camera shroud by flipping it down 

and away from the front of the camera. The 
front of the camera is indicated by the lens 
location.

3.  Adjust the tilt of the camera by loosening the tilt 

angle lock screw as shown in 

Figure 10.1

 and 

pivoting the lens position to the desired range. 
When finished, lock down the camera tilt angle 
by tightening the tilt lock screw.

4.  Adjust the field-of-view and focus rings to 

achieve the desired result. Be sure to lock the 
lens ring thumbscrews by tightening them down. 

5.  Alliance is equipped with a secondary analog video 

port, RCA type, which can be found next to the reset/reboot buttons.  This analog 
port utilizes IQinVision’s exclusive IQfocus utility which allows precise focusing of 
the camera. Note that IQfocus shuts off 5 minutes after Alliance is powered up or 
immediately after Alliance begins sending its digital stream.

 

Rebooting - Depress the reboot key for 2 -3  
seconds then release.

Restoring to Factory Default - While  
pressing the “Factory” key, press and hold  
the “Reboot” key for 2-3 seconds. Keep  
holding the Factory key for 10 seconds,  
then release.

Tilt Lock Mechanism

Factory

Reboot