DeWALT 3800 max psi - 4.0 gpm gas pressure washer w User Guide
12
English
Important Safety Instructions for all
Battery chargers
SAve theSe INStRuctIoNS: This manual contains important
safety and operating instruc tions for battery chargers.
• Before using charger, read all instructions and cautionary
• Before using charger, read all instructions and cautionary
markings on charger, battery pack, and product using battery
pack.
DANGeR: Electrocution hazard. 120 volts are present at charging
terminals. Do not probe with conductive objects. Electric shock or
electrocution may result.
WARNING: Shock hazard. Do not allow any liquid to get inside
charger. Electric shock may result.
cAutIoN: Burn hazard. To reduce the risk of injury, charge only
D
e
WalT rechargeable batteries. Other types of batteries may burst
causing personal injury and damage.
cAutIoN: Under certain conditions, with the charger plugged in
to the power supply, the exposed charging contacts inside the
charger can be shorted by foreign material. Foreign materials of a
conductive nature such as, but not limited to, steel wool, aluminum
foil, or any buildup of metallic particles should be kept away from
charger cavities. always unplug the charger from the power supply
when there is no battery pack in the cavity. Unplug charger before
attempting to clean.
•
•
Do Not attempt to charge the battery pack with any chargers
other than the ones in this manual. The charger and battery
pack are specifically designed to work together.
•
these chargers are not intended for any uses other than
charging D
e
WAlt rechargeable batteries. any other uses may
result in risk of fire, electric shock or electrocution.
•
Do not expose charger to rain or snow.
•
Pull by plug rather than cord when disconnecting charger.
This will reduce risk of damage to electric plug and cord.
•
make sure that cord is located so that it will not be stepped
on, tripped over, or otherwise subjected to damage or
stress.
•
Do not use an extension cord unless it is absolutely
necessary. Use of improper extension cord could result in risk of
fire, electric shock, or electrocution.
•
When operating a power tool outdoors, use an extension
cord suitable for outdoor use. Use of a cord suitable for out-
door use reduces the risk of electric shock.
•
An extension cord must have adequate wire size (AWG
or American Wire Gauge) for safety. The smaller the gauge
number of the wire, the greater the capacity of the cable, that is
16 gauge has more capacity than 18 gauge. an undersized cord
will cause a drop in line voltage resulting in loss of power and
overheating. When using more than one extension to make up the
total length, be sure each individual extension contains at least
the minimum wire size. The following table shows the correct size
to use depending on cord length and nameplate ampere rating.
If in doubt, use the next heavier gauge. The smaller the gauge
number, the heavier the cord.
recommended Minimum Wire size for Extension cords
total Length of cord
25 ft.
total Length of cord
25 ft.
50 ft.
75 ft.
100 ft. 125 ft. 150 ft.
175 ft.
7.6 m 15.2 m 22.9 m 30.5 m 38.1 m 45.7 m 53.3 m
Wire size aWG
18
Wire size aWG
18
18
16
16
14
14
12
•
Do not place any object on top of charger or place the
charger on a soft surface that might block the ventilation
slots and result in excessive internal heat. Place the charger