Netcomm N3G001W User Guide
YML869 Rev1
N3G001W 3G Wireless Router User Guide
N3G001W 3G Wireless Router User Guide
www.netcomm.com.au
9
To Configure WDS click on WDS Setting button and you will be presented with the following page.
WDS is used to wirelessly connect multiple Access Points (in WDS mode), and in doing so extend the wireless
infrastructure to locations where cabling is not possible or inefficient to implement.
infrastructure to locations where cabling is not possible or inefficient to implement.
Notes: Be sure you understand the purpose of WDS mode before continuing with the configuration. And not all Access Point can be use
in WDS mode.
in WDS mode.
To enable WDS please make sure to tick the Enable tick box for Wireless Bridging.
And then type in the MAC address of the remote WDS unit in the Remote AP MAC list. Or you can copy the
one from the Scanned AP’s MAC list. This router can accommodate up to 6 remote MAC addresses.
Click Save to save the settings and Undo to cancel.
And then type in the MAC address of the remote WDS unit in the Remote AP MAC list. Or you can copy the
one from the Scanned AP’s MAC list. This router can accommodate up to 6 remote MAC addresses.
Click Save to save the settings and Undo to cancel.