Aigo dc-t1000 User Guide

Preface

This manual is designed to assist you in using your new digital camera. All 

information presented is as accurate as possible but is subject to change without 

notice.

Copyright

This manual contains proprietary information protected by copyright. All rights are 

reserved. No part of this manual may be reproduced by any mechanical, electronic 

or other means, in any form, without prior written permission of the manufacturer.
© Copyright 2008

Federal Communications Commission (FCC) Compliance

This equipment has been tested and found to comply with the limits for a Class B 

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to 

provide reasonable protection against harmful interference in a residential 

installation. This equipment generates, uses, and can radiate radio frequency 

energy and, if not installed and used in accordance with the instructions, may 

cause harmful interference to radio communications. However, there is no 

guarantee that interference will not occur in a particular installation. If this 

equipment does cause harmful interference to radio or television reception, which 

can be determined by turning the equipment off and on, the user is encouraged to 

try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the 

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Declaration of Conformity

This device complies with Part 15 of the FCC rules. Operation is subject to the 

following conditions:

• This device may not cause harmful interference.
• This device must accept any interference received, including interference that 

may cause undersired operation.

Warning: A shielded-type power cord is required in order to meet FCC emission limits and to prevent 
interference to radio and television reception. Use only shielded cable to connect I/O devices to this 
equipment. Any changes or modifications not expressly approved by the manufacturer may void 
your warranty and service agreement.