Aigo dc-t35 User Guide

Page of 66
y  Before using the camera, please ensure that you read and understand the safety 
precautions described below. Always ensure that the camera is operated correctly. 
y  Do not aim the camera directly into the sun or other intense light sources which 
could damage your eyesight. 
y  Do not try to open the case of the camera or attempt to modify this camera in any 
way. High-voltage internal components create the risk of electric shock when 
exposed. Maintenance and repairs should be carried out only by authorized service 
y  Do not fire the flash too close to the eyes of animals or people, especially for young 
children. Eye damage may result. In particular, remain at least one meter away from 
infants when using flash. 
y  Keep the camera away from water and other liquids. Do not use the camera with 
wet hands. Never use the camera in the rain or snow. Moisture creates the danger 
of electric shock. 
y  Keep the camera and its accessories out of the reach of children and animals to 
prevent accidents or damage to the camera. 
y  If you notice smoke or a strange odor coming from the camera, turn the power off 
immediately. Take the camera to the nearest authorized service center for repair. 
Never attempt to repair the camera on your own. 
y  Use only the recommended power accessories. Use of power sources not 
expressly recommended for this equipment may lead to overheating, distortion of 
the equipment, fire, electrical shock or other hazards. 
FCC Compliance and Advisory 
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 
1.) this device may not cause harmful interference, and 2.) this device must accept any interference 
received, including interference that may cause unsatisfactory operation.   
This equipment has been tested and found to comply with the limits for a Class B peripheral, pursuant to 
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful 
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency 
energy and, if not installed and used in accordance with the instructions, may cause harmful interference 
to radio communication. However, there is no guarantee that interference will not occur in a particular 
installation. If this equipment does cause harmful interference to radio or television reception, which can 
be determined by turning the equipment off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures.   
y  Reorient or relocate the receiving antenna.   
y  Increase the separation between the equipment and receiver.   
y  Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. 
y  Consult the dealer or an experienced radio/TV technician for help.   
Any changes or modifications not expressly approved by the party responsible for compliance could void 
the user’s authority to operate the equipment. When shielded interface cables have been provided with 
the product or when specified additional components or accessories have elsewhere been designated to 
be used with the installation of the product, they must be used in order to ensure compliance with FCC