NorthStar 957 User Manual
Page 130
957 Operator’s Manual, Rev. B
Chapter 10 - Using Special Functions
the CLEAR ALARM key. You may also want to set the anchor
alarm back to the OFF setting.
alarm back to the OFF setting.
Honking for all alarms
Instead of setting all alarms to only beep, you can set all
alarms to honk. This honking starts simultaneously with any
flashing alarm icons. After you set all alarms to honk, an
alarm causes the 957 to emit a sound for half a second,
followed by silence for half a second. This honking sequence
stops when the alarms either automatically clear or you
manually clear them.
alarms to honk. This honking starts simultaneously with any
flashing alarm icons. After you set all alarms to honk, an
alarm causes the 957 to emit a sound for half a second,
followed by silence for half a second. This honking sequence
stops when the alarms either automatically clear or you
manually clear them.
To set all alarms to honk:
1. Press the CURSOR PAD to highlight HONK OUTPUT, then
press the EDIT ALARM menu key.
2. Press the CURSOR PAD to select ALL ALARMS, then press
the ENTER key.
3. Set the
ALARM AUDIO
to
ON if it’s currently off.
Table 7 below describes how to set the anchor alarm and all
other alarms to the desired audio.
other alarms to the desired audio.
Table 7: Beep and honk settings for all alarms
Sound
Type
Setting(s)
Description
Beep
All alarms
Set
ALARM AUDIO
to ON
The 957’s standard alarm beep.
Beep
Anchor alarm
Set
ALARM AUDIO
to ON
Set
ANCHOR ALARM
to
ON
The 957’s standard alarm beep.
Honk
All alarms
Set
ALARM AUDIO
to ON
Set
HONK OUTPUT
to ALL
ALARMS
Alarm icons flash; the 957 simulta-
neously emits an output sound for half a
second, followed by silence for half a
second until the alarm is manually
cleared.
neously emits an output sound for half a
second, followed by silence for half a
second until the alarm is manually
cleared.