NorthStar 957 Installation Instruction
SECTION THREE: Installing and wiring the 2201
957 Installation Manual, Revision C1
Page 21
Figure 10: Mounting on a flat surface (viewed from below)
❷
Make sure the 2201 has enough mounting clearance so
that you can easily connect the cable. For example, mount
the 2201 on the edge of the deck, or drill a small hole in
the deck or other surface to allow the cable to pass
through.
the 2201 on the edge of the deck, or drill a small hole in
the deck or other surface to allow the cable to pass
through.
Wiring the 2201
Connecting the 2201 to the
957
The 50-foot 957POD-CA cable connects the 957 with the 2201.
Both ends of the cable are finished with 7-pin connectors that
plug into the 2201 and 957:
Both ends of the cable are finished with 7-pin connectors that
plug into the 2201 and 957:
1.
Plug the 2201 end of the cable into the 2201, and the
957 end into the 957 connector labelled “GPS.” Note: The
cable’s connectors may look the same, but they are not
interchangeable.
957 end into the 957 connector labelled “GPS.” Note: The
cable’s connectors may look the same, but they are not
interchangeable.
Connector receptacle with 7
male contacts. Mating:
Switchcraft EN3C7FC or
equivalent.
male contacts. Mating:
Switchcraft EN3C7FC or
equivalent.
3x 3/16” - 32UNF - 2B x .48
deep. Mounting holes
equally spaced around a
1.75” diameter circle.
deep. Mounting holes
equally spaced around a
1.75” diameter circle.
1.00 -14UNS-2Bx 1.00 deep.
φφφφ
1.750
NOTE:
You can shorten the 957POD-CA cable, but do not
lengthen it. The cable must be a maximum of 50
feet.
lengthen it. The cable must be a maximum of 50
feet.