NorthStar 957 Installation Instruction

Page of 70
SECTION SIX: Interfacing the 957 system
Page 50
957 INSTALLATION MANUAL, Revision C1
Connecting two 
Northstar units 
You can connect two 957’s and then transfer one of the unit’s 
waypoints and routes into the other. To connect the 957’s, you 
must fabricate an interface cable and terminate both its ends 
with the supplied 6-pin solder-cup style cable connectors. This 
data-transfer cable is not included with the 957. You must 
select a cable; use only shielded, twisted pair.
You can also connect a 957 with a Northstar 952, 951, or 941, 
also using your own data-transfer cable. Each 952, 951, and 941 
that you want to transfer waypoints and routes to or from must 
be using software version 3.12 or higher. 
Assembling the cable
To assemble the cable:
1. Cut the cable to the desired length.
2. Slide the following parts onto each end of the cable, in the 
following order: 
connector backshell
rubber-strain relief boot that fits inside the backshell
twist lock (also known as a quarter turn), ensuring that 
it’s facing in the correct direction.
3. Trim and prepare the wires for soldering to the connector 
body.
4. Terminate the cable, as described below.
Terminating the cable
To terminate the cable:
1. Terminate and solder the appropriate wires to the appro-
priate pins:
For wiring a 957 to a 952/951/941, see Figure 18 on 
page 52
 and Table 9 on page 53. 
2.
Move to Step #3 on page 53.