Garmin quest 2 Quick Reference Card
POWER—press and hold to turn the unit on or off. Press once to
adjust the illumination of your screen.
IN/OUT—press to zoom in or zoom out on the Map page.
MENU—press to view a menu of options for the current page.
Press twice to open the Settings menu. Press and hold to open
the Route Options menu.
SPEAK—press to trigger the unit’s “voice” to repeat the next turn
or current destination when navigating a route. Press and hold to
adjust the volume.
FIND—press to search for cities, addresses, and other POIs.
Press twice to view the Recent Finds menu. Press and hold to
“Route Home”.
PAGE—press to cycle through pages, close the current window
or menu and return to the previous page, or cancel data entry and
restore the previous value.
OK—press to select items. Press to show information pages when
panning the map. Press and hold to save your current location in
My Locations.
Rocker—press up, down, right, or left to highlight options or move
the map pointer.
To turn on the Quest 2:
Press and hold the
Power key on the front of the unit to turn it
on or off.
note: The first time the Quest 2 acquires satellites it may take several
minutes. Afterward, acquisition times are quicker during normal use.
note: If you are prompted to enter a security code, contact your
Toyota dealer.
To install the Quest 2 in your vehicle:
1. Flip the GPS antenna to a 90° angle on the back of the Quest 2.
2. Insert the bottom of the Quest 2 into the bottom of the mount, as
2. Insert the bottom of the Quest 2 into the bottom of the mount, as
shown. The antenna fits through the opening in the back of the mount.
3. Snap the Quest 2 back into the mount so that it is fully seated.
© Copyright 2006 Garmin Ltd. or its subsidiaries
September 2006
190-00675-10 Rev. A
Printed in Taiwan
To find a place and route to it:
1. Press the
FIND key.
2. Use the
Rocker highlight a search category.
Then press the
OK key. A list of places near
your current location appears.
3. Highlight the place you want to visit and
press
OK. An information page appears.
4. Highlight
Route To on the information page
and press
OK. Your Quest 2 calculates the
route. Follow the calculated route to the
destination.
To stop or resume the current route:
1. Press the
MENU key, highlight Route
Options, and press OK. A Route Options
menu appears.
2. Highlight
Stop Navigation or Resume
Navigation, and press OK to stop or start
the active route.
note: When the vehicle is moving, Safe Mode turns on automatically.
If you press FInD while driving, only the Emergency & Government
Services search category is available.
Using the Keys
Finding Places and Routing to Them
Find Page
Information Page
pocket-sized navigator
Quest
®
2
Turning the Quest 2 On and Installing the Unit
Quick Reference Guide