Garmin 2720 gps Quick Reference Card

1.   Align the power plug on the vehicle adapter to the connector and slide 

the plug into the connector until fully seated, as shown to the right.

2.  Slide the locking lever on the mounting base to the left, in the 

unlocked position.

3.  Slide the bottom of the StreetPilot into the mounting base until it 

clicks into place.

4.  Slide the locking lever to the right.
5.  Plug the power adapter into an available cigarette lighter receptacle 

in your vehicle. Route the cable so it does not interfere with vehicle 

operation.

6.  Flip the power switch on the side of the StreetPilot down. 

Follow the route to your destination using the map. As you travel, your StreetPilot guides you to your destination with voice 

prompts, arrows, and directions along the top of the map. If you depart from the original route, your StreetPilot recalculates 

the route and provides new route instructions. 

Read the driving 

directions along the top  

of the map.

Your route is marked with 

a magenta line.

Follow the arrows.

A checkered flag marks 

your destination.

➊

  Touch 

➐

  Enjoy the route! 

➋

  Touch 

Food, Hotel….

➌

 Touch 

Food & Drink.

➍

  Touch a food category.

➎

  Touch the place.

➏

  Touch 

Go To.

StreetPilot

 2720

Warning: For use in vehicles, it is the sole responsibility of the owner/operator of a vehicle with the 2720 installed to place and secure the device so it will not interfere with the vehicle 

operating controls and safety devices, obstruct the driver’s view of driving conditions, or cause personal injury in the event of an accident.

Locking lever

Release tab