Garmin i2 Quick Setup Guide

Page of 2
 Set Up the i2/i3
  Press and hold the 
Power
 button   to 
turn on the i2/i3. Follow the instructions 
on the screen to set up the i2/i3. Roll 
the 
Wheel
 up and down to highlight 
options. Press in to select options.
 Install Software and Load Maps
Do not connect your i2/i3 to your computer until you are told to do so!
1.  Insert the Setup DVD-ROM into your computer’s DVD-ROM 
drive.
  If the welcome screen does not automatically appear, click 
Start
 and then 
Run
 on your personal computer. Type the 
letter of your DVD-ROM drive followed by setup.exe (example: 
D:\setup.exe). Then press 
Enter
.
2.  Follow the instructions on the screen to install software and 
load maps to your i2/i3. 
3.  When MapInstall opens, click the map to select the regions you 
want to load to your i2/i3. Selected maps are shaded pink.
Find a Place and Go!
Select 
Start Navigating
.
Select a destination.
Enjoy the route!
Select a category.
Select 
Food, Hotels,  
and More
.
Select 
Where To?
Tip:
 To narrow your search, select the 
<Spell>
 field and enter letters in the name of  
the place.
 Mount the i2/i3
1.  Place the suction cup mount on your windshield with the lever 
pulled toward you, as shown above.
2.  Press the lever toward the windshield.
3.  Plug one end of the vehicle adapter into the USB port on the 
i2/i3. Plug the other end into a receptacle in your vehicle.
Windshield
USB port
Lever
Power
Wheel
Getting Started
 Insert Batteries
1.  Press down on the tab and pull to remove the battery door.
2.  Insert two AA batteries.
3.  Press down on the battery door as you slide it back into place.
Tab
Setup  
DVD-ROM
Unlock sheet
USB cable
Vehicle adapter cable
i2/i3 and mount
WARNING:
 For use in vehicles, it is the sole responsibility of the owner/operator of a vehicle with the i2/i3 installed 
to place and secure the device so it will not interfere with the vehicle operating controls and safety devices, obstruct the 
driver’s view of driving conditions, or cause personal injury in the event of an accident.
NOTICE TO DRIVERS IN CALIFORNIA AND MINNESOTA:
  State law prohibits drivers in California and 
Minnesota from using suction mounts on their windshields while operating motor vehicles. Other Garmin dashboard or 
friction mounting options should be used. Garmin does not take any responsibility for any fines, penalties, or damages that 
may be incurred as a result of disregarding this notice. (See California Vehicle Code Section 26708(a); Minnesota Statutes 
2005, Section 169.71)
Keep batteries installed in your i2/i3 so it can find satellites quickly. 
Do not mix different types of batteries or old and new batteries.
NOTE:
 Keep your Unlock sheet in a safe place for future reference.