Garmin i5 Quick Setup Guide

➌

1.  Place the suction cup mount on your windshield with the lever 

pulled toward you, as shown above.

2.  Press the lever toward the windshield.
3.  Plug one end of the vehicle adapter into the USB port on the i5. 

Plug the other end into a receptacle in your vehicle.

➋

  Press and hold the 

 button 

 to turn on the i5. Follow the 

instructions on the screen to set up 

your i5 and acquire GPS satellite 

signals. 

 
 

  Roll the 

 up and down to highlight items on the screen. 

  Press the 

 in to select an item on the screen.

  Press 

 to go back to the previous page.

 

  Go outdoors away from tall buildings and trees to acquire 

satellite signals.

Select 

.

➎

Select a destination.

➍

Enjoy the route!

➏

Select a category.

➌

Select 

.

➋

Select 

➊

 To narrow your search, select the 

 field and enter letters in the name of  

the place.

Windshield

USB port

Lever

➊

1.  Press down on the tab and pull to remove the battery door.
2.  Insert two new AA batteries.
3.  Press down on the battery door as you slide it back into place.

Tab

 For use in vehicles, it is the sole responsibility of the owner/operator of a vehicle with the i5 installed to place 

and secure the device so it will not interfere with the vehicle operating controls and safety devices, obstruct the driver’s 

view of driving conditions, or cause personal injury in the event of an accident.

  State law prohibits drivers in California and 

Minnesota from using suction mounts on their windshields while operating motor vehicles. Other Garmin dashboard or 

friction mounting options should be used. Garmin does not take any responsibility for any fines, penalties, or damages that 

may be incurred as a result of disregarding this notice. (See California Vehicle Code Section 26708(a); Minnesota Statutes 

2005, Section 169.71)

i5 and mount

USB cable

Vehicle adapter cable

AA

AA

2 AA batteries 

(not included)