Knoll hd110 User Guide
6
Usage Guidelines
1. Do not look directly into the
projection lens when the lamp is
turned on. The bright light may
harm your eyes.
projection lens when the lamp is
turned on. The bright light may
harm your eyes.
2. Do not block the grills on the
projector. Restricting the airflow
can cause it to overheat and turn
projector. Restricting the airflow
can cause it to overheat and turn
Rear view with enhanced connectivity module attached .
off. If this happens, you must wait.
a minute before turning it back on.
3. Handle the projector as you would any product with glass components. Be especially careful
not to drop it.
4. Avoid leaving the projector in direct sunlight or extreme cold for extended periods of time. If
this happens, allow it to reach room temperature before use.
5. Transport the projector in a vendor-approved hard or soft case.
6. Do not subject projector to prolonged exposure to smoke. Smoke may cause damage to the
projector.
SETTING UP THE PROJECTOR
There are a number of factors to consider when determining where to set up the projector,
including the size and shape of your screen, the location of your power outlets, and the distance
between the projector and the rest of your equipment. But here are some general guidelines.
including the size and shape of your screen, the location of your power outlets, and the distance
between the projector and the rest of your equipment. But here are some general guidelines.
NOTE: To ensure adequate cable access, do not place the projector within 6 inches (.15m) of a wall
or other object.
Position the projector on a flat surface at a right angle to the screen.
The projector should be within 10 feet (3 m) of your power source and within 6 feet (1.8 m) of
your video source(s), unless good quality extension cables are to be used.
When installing the projector on the ceiling, refer to the installation guide that comes with the
Ceiling Mount Kit for more information. To turn the image upside down, see “Ceiling Project”
on page 29. Knöll recommends use of an authorized Knöll ceiling mount. The Ceiling Mount
Kit is sold separately.
on page 29. Knöll recommends use of an authorized Knöll ceiling mount. The Ceiling Mount
Kit is sold separately.
Position the projector the desired distance from the screen.
NOTE: The projector must be at least 5.6 feet (1.7 m) from the projection screen.
The distance from the lens of the projector to the screen, the zoom setting, and the video
format determine the size of the projected image.