Fortinet FortiGate-5000 Hardware Manual
FortiGate-5000 Series Quick Guide
26
01-00000-0294-20060315
Changing jumper settings
FortiGate-5001FA2 security system
lists and describes the FortiGate-5001FA2 connectors.
Changing jumper settings
The JP3 jumper on the FortiGate-5001FA2 module is factory set by Fortinet into
one of two positions (see
one of two positions (see
•
For a FortiGate-5140 or FortiGate-5050 chassis, the jumper connects pins 2
and 3
and 3
•
For a FortiGate-5020 chassis, the jumper connects pins 1 and 2
The jumper must connect pins 2 and 3 if the chassis contains a shelf manager.
Both the FortiGate-5140 and the FortiGate-5050 contain shelf managers, and the
FortiGate-5020 does not.
Both the FortiGate-5140 and the FortiGate-5050 contain shelf managers, and the
FortiGate-5020 does not.
If the JP3 jumper settings are incorrect, when you insert the FortiGate-5001FA2
module into a chassis the module may not start up or may not be able to
communicate with the chassis shelf manager.
module into a chassis the module may not start up or may not be able to
communicate with the chassis shelf manager.
STA
Green
Normal operation.
Red
The FortiGate-5001FA2 is booting or a fault condition exists.
IPM
Blue
The FortiGate-5001FA2 is ready to be hot-swapped (removed
from the chassis).
from the chassis).
Flashing
Blue
Blue
The FortiGate-5001FA2 is changing from hot swap to running
mode or from running mode to hot swap.
mode or from running mode to hot swap.
Off
Normal operation. The FortiGate-5001FA2 module is in
contact with the chassis backplane.
contact with the chassis backplane.
1, 2, 3, 4
Green
The correct cable is connected to the gigabit SPF interface.
Flashing
Network activity at the gigabit SPF interface.
5, 6, 7, 8
Green
The correct cable is connected to the copper 1000Base-T
gigabit interface and the connected equipment has power.
gigabit interface and the connected equipment has power.
Flashing
Network activity at this interface.
Amber
The interface is connected at 1000 Mbps.
Table 6: FortiGate-5001FA2 connectors
Connector Type
Speed
Protocol Description
1 and 2
LC SFP 1000Base-SX
Ethernet
Two gigabit SFP interfaces that can
accept fiber or copper gigabit
transceivers.
accept fiber or copper gigabit
transceivers.
3 and 4
LC SFP 1000Base-SX
Ethernet
Two gigabit SFP interfaces that can
accept fiber or copper gigabit
transceivers.
accept fiber or copper gigabit
transceivers.
5, 6, 7, 8
RJ-45
1000Base-T
Ethernet
Copper gigabit connection to
10/100/1000Base-T copper networks.
10/100/1000Base-T copper networks.
CONSOLE DB-9
9600 bps
RS-232
serial
serial
Serial connection to the command line
interface.
interface.
USB
USB
USB key firmware updates and
configuration backup (FortiOS v3.0).
configuration backup (FortiOS v3.0).
Table 5: FortiGate-5001FA2 module LEDs
LED
State
Description