Sherwood rd-8108 User Guide
REMOTE
SENSOR
MASTER VOLUME
ON/STANDBY
POWER
STANDBY
ON/
OFF
TUNING/PRESET
ADJUST
PHONES
CHANNEL
SELECTOR
VIDEO
L - AUDIO - R
VIDEO 3
BAND
FM MODE
T/P MODE
TONE MODE
SPEAKER
SETUP
DYNAMIC
RANGE
MEMO/ENTER
CINEMA EQ
ON/OFF
SPEAKER
ST TUNED TIME
DIRECT
PRESET
PRO LOGIC II C M DSP
DIGITAL EX
DTS ES
AUTO DIGITAL
SLEEP
dB
kHz
MHz
kHz
MHz
MEM
ft
AUDIO/VIDEO RECEIVER RD-8108
INPUT SELECTOR
AUDIO
VIDEO
PL MUSIC PARAMETER
7CH DIRECT
DSP MODE
SURROUND MODE
AUTO
STEREO
DIGITAL
INPUTS
INPUTS
Ⅱ
AUTO
1
2
3
4
5
6
7
8
9
0
T.TONE
DSP
STEREO
POWER
AUDIO
VCR
SPK SET
ADJUST
M1
M2
M3
AUDIO SEL.
OSD
SETUP
SLEEP
DISPLAY
DIMMER
RETURN
P.SCAN
TUNER
CD
AUX
VIDEO1 VIDEO2 VIDEO3
TAPE
7CH DIR.
+10
TUNE
PRESET
ENTER
SUBTITLE
ZOOM
VOLUME
MUTE
CH SEL.
CH/LEVEL
MACRO
DVD
CABLE
SAT
CD
AUX
TV
STANDBY
PL
PARA.
MENU
UNIVERSAL REMOTE CONTROL
RNC-40
7m
30
30
1 1
• Use the remote control unit within a range of
about 7 meters (23 feet) and angles of up to 30
degrees aiming at the remote sensor.
degrees aiming at the remote sensor.
1
Enter the setup code for each component
other than this receiver you wish to
control. For details, refer to “Entering a
setup code” on page 12.
other than this receiver you wish to
control. For details, refer to “Entering a
setup code” on page 12.
2
Turn on the component you want to
operate.
operate.
3
Press the DEVICE button on the remote
control corresponding to the component
you wish to operate.
control corresponding to the component
you wish to operate.
4
Aim the remote control at the REMOTE
SENSOR of the component you wish to
control and press the button corresponding
to the operation you want.
SENSOR of the component you wish to
control and press the button corresponding
to the operation you want.
• When operating a Sherwood CD player or tape deck
using digi link system remote control, aim the remote
control at the REMOTE SENSOR of this receiver.
control at the REMOTE SENSOR of this receiver.
However, to operate a Sherwood DVD player, aim at
the REMOTE SENSOR of the corresponding
component.
the REMOTE SENSOR of the corresponding
component.
ENGLISH
LOADING BATTERIES
1
2
• Remove the batteries when they are not used for a
long time.
• Do not use the rechargeable batteries(Ni-Cd type).
• Be sure to use alkaline batteries.
• Be sure to use alkaline batteries.
Remove the cover.
Load two batteries matching the polarity.
• When the remote control does not operate, the old batteries should be replaced. In this case, load new batteries within
several minutes after removing old batteries.
• If the batteries are removed or have been exhausted for a longer period of time, memorized contents will be cleared.
Should this happen, you should memorize them again.
2
1.5V
(“AAA” size)