Hussmann l Installation Instruction
Merchandisers
®
1
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 (Printed in U.S.A.)
NOTE:
Be sure merchandisers
have been leveled according to the
installation instructions. Carefully
unpack and inspect the Wall/
Island Joint Kit, making sure there
is no breakage or damage. Be
sure factory-installed nut retainers
and alignment pins are in place.
installation instructions. Carefully
unpack and inspect the Wall/
Island Joint Kit, making sure there
is no breakage or damage. Be
sure factory-installed nut retainers
and alignment pins are in place.
S
ST
TE
EP
PS
S
1
Apply Gaskets —
— 1 and 2
as shown in Figure 1.
• Remove paper backing as
gasket is applied.
•
• Remove paper backing as
gasket is applied.
•
Lap gaskets at lower corners.
•
Check that there are no gaps
between gasket and merchan-
dis
dis
er.
• Do not stretch gasket,
especially around corners.
• Do not butt gaskets; always
overlap joints.
especially around corners.
• Do not butt gaskets; always
overlap joints.
A.
Remove Honeycomb at
end to be joined by lifting up
at bottom and pulling for-
ward.
at bottom and pulling for-
ward.
B.
Lift out Rear Panel.
C.
Remove Front Panel.
PARTS LIST
Item No.
Item No.
Quantity
Description
L
LG
LN LNG
LI
LIG
1.
1
1
1
1
1
1
Gasket
1
/
2
x
1
/
2
x 120
2.
1
1
1
1
1
1
Donut Gasket
Wall/Island Merchandiser
(Solid and Glass Front) Joining Instruction
L, LG, LN, LNG, LI, LIG
Splashguard Brackets
MUST BE INSTALLED
Before Piping Case.
For Low Temperature Merchandisers
Figure 1. Installing Gasket for Solid and Glass
See Figures 1, 2 and 3 for gasket, hole and fastener locations for all models.
NOTE: A
PPLY
G
ASKET
T
O
O
NE
C
ASE
O
NLY
.
NOTE:
Refer to the
Installation Manual to
install splashguard
March, 1998
P/N 403099A
JOINT
JOINT
KIT
KIT
L
LG
L N
LNG
LI
LIG
,
1/
2X
1/
2X180
Foam Tape Gasket
Donut Gasket