Planar LX1200 User Guide

LX1200TI User’s Guide (020-0512-01A)              

17

Once the LX1200TI is mounted in place, connect it to the computer (or other 
video source) and the 12 VDC power supply as follows.

 
 
 

1.  As needed, route any data and power cables from the computer to the 

  

monitor.

 

2.  Make sure the computer is turned off .

 

3.  Connect the 12 VDC power supply cable to the monitor’s power supply.

 

 

4.  Connect the power supply and power interrupt cables (for the 

 

  All-in-One power switch, if your computer or docking station is so 

 

  equipped) to the connectors on the bottom of the monitor. See the 

 

  following diagram for connector locations. 

Note:  This procedure refers to connections to and from the computer. 
 

However, depending on your particular hardware confi guration, these 

 

connections may be to a dock or other device rather than directly to 

 the 

computer.

Note:  Use a 5-Amp fuse in line to the power source.

 

Also, to prevent vehicle battery from draining, you should install a 

 

device that shuts off  power to the monitor while the monitor is 

 

inactive. (An example is Lind Electronic’s Vehicle Battery Voltage 

 

Shutdown Timer - www.lindeletronic.com).

Dimming Dial

USB Type A

Volume Dial

Speaker Vent

USB Type A

USB Type B Upstream

VGA

Power 12 V

Audio

Remote PC Shutdown