Planar PT1910MX User Guide

Page of 28
 
11 
 
 
Connecting the Display (Figure 11.1) 
To setup this display, please refer to the following figure and procedures. 
1.  Be sure all equipment is turned off. 
2.  Connect the AC power cord to the power connector on the monitor and the 
other end into an electrical outlet (11.1). 
3.  Connect the D-SUB or DVI cable from the display’s VGA or DVI input 
connector to the D-SUB or DVI connector of your host computer and 
tighten the screws (11.1). 
4.  Connect the Audio-In cable from the audio input port of your display to the 
Audio-out port of your computer (11.1). 
5.  Connect the RS-232 or USB cable from the RS-232 or USB port of your 
display to the RS-232 port (11.1) or USB port (11.1) of your computer. 
6.  Configure the touch screen.    Refer to the “Touch Screen Driver 
Installation” section on Page 20. 
7.  Once the touch screen is configured, the monitor is ready for use. 
 
To ensure the LCD display works well with your computer, please configure 
the display mode of your graphics card to make it less than or equal to 1280 
x1024    resolution and make sure the timing of the display mode is 
compatible with the LCD display. 
 
We have listed the compatible “Video Modes” of your LCD   
display in the appendix for your reference.