Planar PT1945RW User Guide

To setup this display, please refer to the following figure and procedures.

1.  Be sure all equipment is turned off.

2.  Connect the AC power cord to the power connector on the monitor and the other end 

       into an electrical outlet (

8.1).

3.  Connect the D-SUB cable from the display's VGA input connector to the D-SUB  

       connector of your host computer and tighten the screws (

8.1).

4.  Connector the audio-in cable from the audio input port of your display to the audio out

       port of your computer (

8.1).

5.  Connect the RS-232 or USB cable from the RS-232 or USB port of your display to the

       RS-232 port (

8.1) or USB port (8.1) of your computer.

6.  Configure the touch screen.  Refer to the “Touch Screen Driver Installation” section on
       page 21.
7.  Once the touch screen is configured, the monitor is ready for use.

To ensure the LCD display works well with your computer, please configure the 
display mode of your graphics card to make it less than or equal to 1280 x 1024  
resolution for PT1945R, 1366 x 768 for PT1945RW and make sure the timing of the 
display mode is compatible with the LCD display.
We have listed the compatible “Video Modes” of your LCD display in the appendix 
(on page 20) for your reference. 

7