Planar lc640.480.21-065 Product Manual
LC640.480.21-065 Operations Manual (OM610-00)
17
Connectors
The LC640.480.21-065 display has four connectors on the back near one side of the
display. J1 is the video input and backlight control connector, J2 is the backlight inverter
and heater connector, and J3 and J8 are the connectors for tethering the ambient light
sensor.
display. J1 is the video input and backlight control connector, J2 is the backlight inverter
and heater connector, and J3 and J8 are the connectors for tethering the ambient light
sensor.
Figure 9. Connector Locations.
Video Input and Backlight Control Connector (J1)
The video input and backlight control signals are connected to the display through
a 40-pin, dual-row, 1.27 mm pitch, square pin, locking connector (Samtec
FTSH-120-01-L-DV-EJ-A). The mating connector is available through Samtec as
a cable assembly (FFSD series). Consult your Samtec representative (1-800-
SAMTEC) for cable and connector options. Table 11 on the following page lists
the pin assignments for the J1 connector.
a 40-pin, dual-row, 1.27 mm pitch, square pin, locking connector (Samtec
FTSH-120-01-L-DV-EJ-A). The mating connector is available through Samtec as
a cable assembly (FFSD series). Consult your Samtec representative (1-800-
SAMTEC) for cable and connector options. Table 11 on the following page lists
the pin assignments for the J1 connector.
J1
J2
Pin 1
J3
J1
J8
Pin 1
Pin 1
1
SW1
ON