Sonance mariner 52ss User Guide

3. If the installation requires that the speaker be mounted vertically and

that it pivot in the vertical dimension (or be mounted horizontally
and pivot in the horizontal dimension), you must use the included
mounting base in addition to the bracket:

3a. Run the speaker wire through the hole in the wall half of the base.

3b. Attach the wall half of the base to the mounting surface using 

hardware (not included) that is appropriate for the type of surface.

3c. Pass the speaker wire through the slot in the bracket half of the base.

3d. Use the included hardware and allen wrench to assemble the base

halves.

3e. Use the included 4 self-tapping

screws to attach the bracket to
the mounting base.

• Before attaching the bracket to

the base, pass the speaker wire
through the hole in the center
of the bracket.

• To adjust the speaker, loosen

the hex screw with the sup-
plied allen wrench, pivot the
bracket/base and tighten the
hex screw.

4. If the installation requires that

the speaker be mounted on a
pole you can attach the brackets
to the pole using 2½” U-bolts
(not included).

5. Feed the speaker wires from the

bracket into the wire entry
grommet on the back of the
speaker, through the wire tun-
nel and out the opening on the
speaker’s front panel.

• The grommet forms a water-

resistant seal around the speaker wire.

• 

Make sure there is enough slack in the wire to allow 
the speaker to pivot on the bracket.

6. Slide the speaker onto the bracket until the locks snap into place.

• Pull enough wire through the front of the speaker to allow connec-

tion to the terminals.

7. Connect the speaker wires to the speaker’s terminals:

a. Strip about ½” of insulation from each conductor and twist the

strands together or tin them with solder.

b. Press-down on the tops of the connectors to open them.

c. Insert the wires into the connector holes as shown.

d. Release the connectors.

• The binding post connectors can accept wire up to 14 gauge.

• Double-check that you connected all of the wires properly (amplifier

‘+’ to speaker ‘+’; amplifier ‘–’ to speaker ‘–’) at all connections.

4. Attaching the 
bracket to a pole

Base

(Wall Half)

3a: Pass wire
through
hole

3b: Attach
base to
mounting
surface

Base

(Bracket Half)

Base

(Wall Half)

Base

(Bracket Half)

Base

(Wall Half)

3c: Pass wire
through
slot

Hex

screw

Lock

washer

Washer

3d: Insert screw
through slot and
thread into
base

3e: Pass wire through bracket and attach
bracket to base

LEFT

RIGHT

7. Connection
terminals

5. Wire
entry
grommet

6. Attach speaker
to bracket

2

I N S T R U C T I O N   M A N U A L

S O N A N C E   L A N D S C A P E   S E R I E S
M A R I N E R

®

S I N G L E - S T E R E O

O U T D O O R   S P E A K E R S