Valcom v2991 Installation Instruction

 

 

Issue 1 

1 

947611 

   

 
 
 
 

The V-2991, Call Switch with Volume Control, is 
designed to be used with Valcom Talkback Page 
Control Units with the remote calling feature.  
The V-2991 provides a call button for connection 
to customer provided signaling equipment. 
 

•  Modern décor styling 

•  Designed to fit in a standard single-gang 

electrical box 

•  No external power source required 

•  Black "Call" button for call annunciation 

•  Built-in Volume Control 
 

•  4.50"H x 2.75"W x 1.00"D 

(11.43cm H x 6.99cm W x 2.54cm D) 

•  0.2 lbs. (.09 kg) 
  

These instructions cover only the installation 
procedures for the Valcom V-2991.  Consult the 
installation instructions of other equipment for 
information relative to each piece of equipment. 
 
1.  Connect switch inputs from control unit to  

V-2991 as shown in connection diagram. 

2.  Connect audio Tip and Ring from control 

unit to V-2991 as shown in connection 
diagram. 

3.  Connect V-2991 to audio Tip and Ring of 45 

Ohm Talkback Speaker. 

4.  Press call button to test loudness of tone at 

speaker and adjust volume of tone through  
cut-out on the front of the V-2991 enclosure 
using a 1/16 inch flat tip screwdriver. 

5.  Place V-2991 over standard single-gang 

electrical box and fasten in place using the 
two screws provided.