Velodyne cht-10r User Manual
P
8
Figure 2. Installation Using Stereo Line-Level Inputs
I
O
TO SATELLITE SPEAKERS
PRE-AMP
LEFT
RIGHT
MAIN OUTPUTS
AMPLIFIER
MAIN INPUTS
LEFT
RIGHT
MAIN OUTPUTS
LEFT
RIGHT
+
R
-
-
L
+
SPEAKER LEVEL INPUT
OFF
POWER
ON
LOW-PASS
CROSSOVER
40 Hz
80 Hz
120 Hz
SUBWOOFER
VOLUME
VOLUME
MIN
MAX
WARNING: TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK. DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE.
OR ELECTRIC SHOCK. DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
AVIS:
RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
0
180
PHASE
0
0
POWER
ON
AUTO
SUBWOOFER
DIRECT
INTERNAL
X-OVER
X-OVER
OUTPUT
INPUT
R
L
LFE
VELODYNE ACOUSTICS, INC.
SERIAL # LABEL
230V~
50Hz
F 4A L
SPL-800i
TM
SPEAKER-LEVEL CONNECTIONS
Figure 3 shows an easy way to connect your Velodyne subwoofer
directly to your receiver or integrated amplifier, if it lacks line-level
outputs. You may also connect your satellites directly to your receiver or
amplifier along with the subwoofer. Your receiver or amplifier will not
notice the additional load of the subwoofer due to the high input
impedance.
directly to your receiver or integrated amplifier, if it lacks line-level
outputs. You may also connect your satellites directly to your receiver or
amplifier along with the subwoofer. Your receiver or amplifier will not
notice the additional load of the subwoofer due to the high input
impedance.
Caution!!! To avoid damage to your main amplifier, be sure to
maintain correct polarity when making all connections. Red
(positive) to red, and black (negative) to black. Be sure that
all connections are tight, and that there are no loose strands or
frayed wires.
maintain correct polarity when making all connections. Red
(positive) to red, and black (negative) to black. Be sure that
all connections are tight, and that there are no loose strands or
frayed wires.
9