Pyle plcd10ch User Manual

88-D0040-11

HANDLING THE DISCS

Dirt, dust, scratches and warpage cause sound skips during playback and a
deterioration of sound quality. How to take care of your disc:

1. Use compact discs that have the mark shown on the right.
2. Fingerprints and dust should be carefully wiped off the disc’s signal surface (glossy

side) with a soft cloth. Unlike conventional records, the compact disc has no
grooves to collect dust and microscopic debris, so gently wipe with a soft cloth
should remove most particles. Wipe in a straight motion from the inside to the
outside of the disc. Small dust particles or light stains will have absolutely no effect
on reproduction quality.

3. Never use such chemicals as record sprays, antistatic sprays or fluid, benzene or

thinner to clean compact discs. Such chemicals would irreparably damage the
disc’s plastic surface.

4. Discs should be put back in their cases after to avoid serious scratches that could

cause sound skip.

5. Do not expose discs to direct sunlight, high humidity, or high temperatures for

extended periods of time. Long exposure to high temperatures can warp the disc.

6. Do not stick paper or write anything with a ball point pen on the disc surface.

TROUBLESHOOTING

An error made in operation or in the connections is sometimes mistaken for a failure
or breakdown. Perform the checks described in the following table before calling in
the servicing engineer.

Symptom Cause

Remedy

No power.

Improper connection.

Check connections.

Magazine cannot Direction in which it is

Insert it in proper direction.

be installed.

inserted is wrong.

CD is not played. Disc has been loaded

Load disc with play side facing

upside down.

up.

Noise is heard

Large scratches on disc or

Compare sound with another

during playback

warped disc.

disc. If sound from second disc

or sound is

is acceptable, first disc is

intermittent.

defective.

Extremely dirty disc.

Clean disc.

Transit screws still in place. Remove screws (x 3) on bottom

of unit and then use.

Built-in anti-vibration

Install board in proper direction.

board is installed in wrong

(Refer to “installation” in

direction.

Operating Instructions.)