Viewsonic PJ400 User Manual
ViewSonic PJ400
19
Searching an input signal
1. Press the SEARCH button on the remote control.
The projector will begin to check its input ports in order to
find any input signals. Then when an input is found, the
projector will stop searching and display the image. If no
signal is found, the projector will return to the state selected
before the operation.
find any input signals. Then when an input is found, the
projector will stop searching and display the image. If no
signal is found, the projector will return to the state selected
before the operation.
RGB Ö S-VIDEO Ö VIDEO
×═════════════╝
×═════════════╝
Selecting an aspect ratio
1. Press the ASPECT button on the remote control.
Each time you press the button, the projector switches the
modes for aspect ratio in turn.
modes for aspect ratio in turn.
At a RGB signal
NORMAL Ö 4:3 Ö 16:9
×═════════╝
At a video signal / no signal
4:3 Ö 16:9
×═══╝
NORMAL Ö 4:3 Ö 16:9
×═════════╝
At a video signal / no signal
4:3 Ö 16:9
×═══╝
● The NORMAL mode keeps the original aspect ratio of the signal.
● At a HDTV component video signal of 1125i (1080i) or 750p (720p), only 16:9
mode can be selected.
● Performing the automatic adjustment initializes the aspect ratio setting.
● At a HDTV component video signal of 1125i (1080i) or 750p (720p), only 16:9
mode can be selected.
● Performing the automatic adjustment initializes the aspect ratio setting.
Adjusting the zoom (magnifying power)
1. Press the ZOOM +/- button on the remote control.
A dialog will appear on the screen to aid you in adjusting
the zoom.
the zoom.
2. Use the cursor buttons +/- to adjust the zoom.
To close the dialog and complete this operation, don’t
perform operation for a few seconds.
perform operation for a few seconds.
Adjusting the focus
1. Use the focus ring to focus on the picture.