Vidikron VL-26HD User Guide
Vidikron VL-26/VL-32 Owner’s Operating Manual
39
Baud Rate: Select Baud Rate from the ISF Calibration menu to set the data transfer rate of the
DView’s RS-232 SERVICE port. (This setting must match the data rate of the device connected
to the RS-232 input.)
DView’s RS-232 SERVICE port. (This setting must match the data rate of the device connected
to the RS-232 input.)
Command Ack: The Command Ack setting enables or disables the echo of serial commands
at the source. When set to on, commands sent from the serial controller (PC or
control/automation system) are logged and/or displayed on-screen. If this is not desired, set
Command Ack to Off.
at the source. When set to on, commands sent from the serial controller (PC or
control/automation system) are logged and/or displayed on-screen. If this is not desired, set
Command Ack to Off.
Factory Reset: To reset all DView settings to their factory defaults, select Factory Reset from
the ISF Calibration menu and press ENTER. This command is not undoable. Use it with
caution!
the ISF Calibration menu and press ENTER. This command is not undoable. Use it with
caution!
Splash Duration: Use Splash Duration to control how long the DView splash screen remains
on-screen after power-up; see Figure 4-6. To prevent this screen from appearing, set the
Splash Duration to 0.
on-screen after power-up; see Figure 4-6. To prevent this screen from appearing, set the
Splash Duration to 0.
Figure 4-6. DView Splash Screen
CALIBRATED FOR: