Vizualogic ford expedition Installation Instruction
2004
Ford Expedition
Seatback Monitor System
99-9018-001 1/04
Installation Manual
1493 Bentley Drive • Corona, CA 92879 • 909-272-1996 • 800-624-7960 • Fax 909-272-1584
www.vizualogic.com
Copyright © 2003 TMI Products, Inc.
All Rights Reserved
Corona, CA U.S.A.
060300
Video Module Installation
1. Place A/V module in a well protected area under a seat or behind
a panel.
2. Connect the 12V harness to the same 12V+ and 12V Ground as the
Video Source Unit(s).
3. Insert 12V harness connector into A/V module.
4. Insert video cable from Source.
5. Insert video output cable connecting the VizuaLogic Monitor.
6. Install I/R extender cable from source unit to A/V module.
4. Insert video cable from Source.
5. Insert video output cable connecting the VizuaLogic Monitor.
6. Install I/R extender cable from source unit to A/V module.
12V Power Installation
We recommend the installation of a main power switch for the entire video
system. The circuit should be marked to assist the consumer in locating the
correct vehicle fuse for the video system in the case of a system failure.
system. The circuit should be marked to assist the consumer in locating the
correct vehicle fuse for the video system in the case of a system failure.
Winter 2004
Advantage
™
Series