Sony DSC-TX7 Reference Guide

Ta
ble
 of
 

Op
e

MENU/Settin

In

79

GB

TransferJet is a close-up, wireless transfer technology that allows data to be transferred by 
closely aligning two products that you want to communicate with each other.
To find out whether your camera is equipped with the TransferJet function, check for the 

 

(TransferJet) mark on the bottom of the camera.
Using a Memory Stick with TransferJet (sold separately) allows images to be transferred 
between TransferJet-compatible devices.
For more details on TransferJet, see the operating instructions supplied with Memory Stick with 
TransferJet.

1 Insert a Memory Stick with TransferJet into the 

camera and press the 

 (Playback) button.

2

 (Send by TransferJet) 

t desired mode

When the buttons are not displayed on the left side of the LCD 
screen, touch 

.

3 Transfer images by closely aligning the 

 (TransferJet) marks on the 

camera and other device.

A notification sound is emitted when connection is made.

• Only still images can be transferred.
• Up to 10 images can be transferred at once.
• First, set [TransferJet] to [On] by selecting 

 

t  

(Settings)

 

t

 

 (Main Settings) (page 115).

• While aboard an airplane, set [TransferJet] to [Off] by selecting 

 

t

  

(Settings)

 

t

  

(Main 

Settings) (page 115). In other cases, always follow all regulations governing the location in which the 
camera is being used.

• The connection is cut if transfer cannot be made within about 30 seconds. If this happens, select [Yes] 

and realign the two 

 (TransferJet) marks on the camera and another device.

• Memory Stick with TransferJet and camera models with TransferJet are not sold in some countries and 

regions due to local laws and regulations.

• Set the [TransferJet] function to [Off] in countries and regions other than where you purchased your 

camera. Depending on the country or region, if you use the TransferJet function, you may be liable due to 
local restrictions on transmission of electromagnetic waves.

Sends the currently displayed image in single-image mode.

You can select and send multiple images.
After step 2, perform the following.

1

Select an image to be sent, then touch it.
Repeat the above steps until there are no more images to 
be sent.
Touch an image with a 

 mark again to release the 

 

mark.

2

Touch [OK] 

t [OK].