JVC GR-DV3 User Manual

EN 

It is also possible to copy recorded scenes from the camcorder onto other video unit equipped with a DV
connector. Since a digital signal is sent, there is little if any image or sound deterioration.

● You cannot use the battery pack installed in the

● If the remote control is used when both the player

and recorder are JVC video units, both units will
perform the same operation. To prevent this from
happening, press the buttons on both units.

● For Digital Dubbing, this camcorder can be

connected only to one device at a time. This
camcorder can also be used as a recorder.

● If a blank portion is played back during dubbing, an

unusual image may be dubbed.

● Even though the DV cable is connected correctly,

sometimes the image may not appear in step 3. If the
above occurs, turn off power and make connections
again.

● The image with Digital Zoom, Fade/Wipe Effects,

P.AE/Effects and Snapshot is not output from the DV
OUT/IN connector. Only the original playback image
is output from it.

Make sure the camcorder's power is off.

Connect the camcorder to your video unit
equipped with a DV connector using the DV
cable (optional) as shown in the illustration.

Press the Play button (4) to play back the
source tape.

While watching the playback on the monitor,
engage the DV connector-equipped video
unit's record mode from the spot on the source
tape you want to begin recording.

1. Select the recording mode (

Z

 pg. 15).

2. Turn the Power Dial to “PLAY” while pressing down the lock button located on it.
3. Connect the DV cable as shown in the illustration and load a cassette to record on.
4. Press the START/STOP button to engage the Record-Pause mode. “DV IN” appears on the screen.
5. Press the START/STOP button to start recording. “DV IN” changes to “

”.

6. Press the START/STOP button again to engage the Record-Pause mode. “

” returns to “DV IN”.