JVC GR-DVL120 Instruction Manual

 EN

  

Separate the Velcro strip.

Pass your right hand through the loop and grasp

the grip.

Adjust your thumb and fingers through the grip, to

easily operate the Recording Start/Stop button and
Power Switch and Power Zoom Lever. Be sure to
fasten the Velcro strip to your preference.

Set the Power Switch to “

” or “

” while

pressing down the Lock Button located on the switch.

Turn the Diopter Adjustment Control until the

indications in the viewfinder are clearly focused.

Make sure the battery pack is removed. Following

the illustration, thread the strap through the eyelet 

1

,

then fold it back and thread it through the buckle 

2

.

Repeat the procedure to attach the other end of the
strap to the other eyelet 

3

 located under the Grip

Strap . Confirm the strap is not twisted.

When attaching the camcorder to a tripod, extend its
legs to stabilize the camcorder. It is not advised to
use small sized tripods. This may cause damage to
the unit by falling over.

To attach the camcorder to a tripod, align the

direction stud and screw to the mounting socket and
stud hole on the camcorder. Then tighten the screw
clockwise. Some tripods are not equipped with studs.

2

1

3