Lexmark X7170 Installation Instruction
Install the print cartridges.
4
If you are using your All-In-One with a computer, continue with the following step.
If you are using your All-In-One without a computer, you are finished.
Install the software.
5
Install the software.
5
Windows
Macintosh
Make sure your
computer is on.
computer is on.
1
Connect the USB cable.
2
Click Cancel on all New Hardware Screens.
3
Make sure your
computer is on.
computer is on.
1
Connect the USB cable.
2
Click Install.
5
Open the scanner unit.
1
Remove the sticker and tape
from the print cartridges.
from the print cartridges.
2
Insert the print cartridges.
3
Close the scanner unit.
4
1
2
Insert CD1.
4
Insert CD1.
3
If this install screen does not
appear, click Start
appear, click Start
Æ
Run and
then type D:\setup, where D is
the letter of your CD-ROM drive.
the letter of your CD-ROM drive.
2
1
Left
Right
Important: After installation is
complete, remember to enable
your anti-virus software.
complete, remember to enable
your anti-virus software.
To prevent errors during installation:
1 Close all open programs.
2 Temporarily disable any anti-virus
2 Temporarily disable any anti-virus
software. For help, refer to your
program documentation, or
contact the software manufacturer
for support.
program documentation, or
contact the software manufacturer
for support.
Important: After installation is
complete, remember to enable
your anti-virus software.
complete, remember to enable
your anti-virus software.
1
2
!
To prevent errors during installation:
1 Close all open programs.
2 Temporarily disable any anti-virus
2 Temporarily disable any anti-virus
software. For help, refer to your
program documentation, or
contact the software manufacturer
for support.
program documentation, or
contact the software manufacturer
for support.
!
Double-click:
4
1
2
3
1
2
www.lexmark.com