Alpine cva-1014 User Guide

      → External CD        → External DVD
              Changer 

←             DVD changer ←

Use this function when connecting the optional
CD/DVD player, changer.

Press BAND/TEL. to switch the Disc mode in the
CD/DVD changer mode.

Example

You can operate a connected external audio
processor from the CVA-1014.

When an external audio processor is connected,
press bass engine to activate Audio Processor
mode.

Press a preset button (1 through 3) to select
the desired function, and then g or f to
adjust settings.

When the ERA-G310/ERA-G320/CDA-5755/
PRA-H600/PXA-H510/PXA-H900 is connected

preset 2: Subwoofer phase control

(NORMAL/REVERSE)

∗

1

preset 3: Recalling the stored settings

(Preset 1 through 6)

∗

2

When the PXA-H400 is connected

preset 1: Bass/Treble control (-7 ~ +7)
preset 3: Recalling the stored settings

(Preset 1 through 4)

When the PXA-H700/PXA-H701 is connected

preset 1: Setting the MX mode

(MX compatible sources only)

preset 2: Subwoofer phase control

(NORMAL/REVERSE)

∗

1

∗

1

↔ 180°

↔ REV

∗

2

Press bass engine to return to normal mode.

NOTE
For details about external audio processor operation, see
the owner’s manual of the external audio processor.

When using the optional expansion box (KCE-
104V), you can use this function.

After carrying out steps 1 to 3 of “To display the
SETUP screen” (page 33), perform the operation
shown below.

When the monitor is open, press and hold
MUTE/SETUP for at least 2 seconds. The
SETUP screen appears.

Press preset 5 to activate the SYSTEM  setting
mode. Press preset 5 again to select SPE.ANA.

Press g or f to select ON or OFF.

Set to ON, then press V.SEL to select the
Spectrum Analyzer display (refer to
“Simultaneous Operation” on page 43).

For any other settings, press preset 5 or another
preset button.

After setting is completed, press MUTE/SETUP
to return to normal mode.

NOTE
When an external Audio Processor is connected,
Spectrum Analyzer is displayed only in AM or FM mode.

f

g