Hitachi DZ-MV580A User Manual

Page of 187
English
172
Troubleshooting
Check to see the following before asking for a repair. If the suggested solution still cannot restore the DVD 
video camera/recorder to normal, do not attempt to repair it yourself, but consult your dealer. 
Power supplies
Symptom
Cause and Correction
Reference 
page
Battery cannot be 
charged.
Is the ambient temperature too low or too high?
Charge the battery at 50-86°F (10-30°C).
39
Is the battery abnormally hot?
Remove the battery, leave it for a while to cool down, then charge it.
Is the DC power cord connected to AC adapter/charger? Unplug it.
Has the battery been unused for a long time?
Remove the battery, and then reattach it. If the battery is still not 
charged, it may be dead: Purchase a new one.
*
If the battery does not charge after you try the above four 
procedures, it may be dead: Purchase a new battery.
Battery weakens fast
Are you using the DVD video camera/recorder where the 
temperature is low?
A fully charged battery (DZ-BP14S or DZ-BP14SW) may be 
discharged sooner than usual at low temperatures. Keep extra 
batteries on hand.
41
Battery may be dead.
The performance of battery will deteriorate if it is used for an 
extended period of time or frequently: Purchase a new battery.
42
The CHARGE indicator 
on AC adapter/charger is 
blinking.
Is the ambient temperature too low or too high?
Charge the battery in environment where the temperature is 50-
86°F (10-30°C). 
The battery has possibly discharged excessively. Continue 
charging: After a while, the battery will be charged to the specified 
voltage, and the CHARGE indicator will light. Then the battery 
charge will be completed normally.
39
Power turns off 
immediately after being 
turned on.
Is battery charged?
Charge it.
39
When power is turned 
on, the LCD screen will 
turn on and off.
Power goes off 
unexpectedly.
Is Power Save set to “On”? 
If the powered DVD video camera/recorder is left for as long as 5 
minutes without recording or playback with “Power Save: On” 
specified, it will automatically turn off to save battery power. To 
restart recording in this case, set the power switch to “POWER OFF” 
and then set it to “
O
 VIDEO”. You can also specify “Power Save: Off” 
to stop automatic power off.
102
Power cannot be turned 
off.
Detach the battery or AC adapter/charger once, and then press the 
RESET button of DVD video camera/recorder: Reattach a power 
supply to DVD video camera/recorder before turning it on again.