Hitachi DZ-MV580A User Manual

English

Set the power switch to 
“POWER OFF” to turn the 
DVD video camera/
recorder off.

Press down the DISC EJECT 
button once and release it. 

In a moment, the cover of 
disc insertion block will 
open slightly.

Gently open the cover until 
it stops.

When the cover is fully 
open, the disc will slightly 
come out from the disc 
guide, and stop.

Remove the disc.

Hold the top of Round 
DVD Holder as shown in 
the illustration and 
gently pull it out.

Be careful not to touch the 
disc exposed portion when 
removing the disc.

Gently push the section 
indicated “PUSH CLOSE” 
on the cover of disc 
insertion block, to close the 
cover.

Even after the DVD video camera/recorder is turned on, 
the disc can be removed unless it is in recording status. 
Hold down the DISC EJECT button for approximately 2 
seconds, and then release it to remove the disc. (The 
DISC EJECT indicator on the LCD screen will blink.) It is 
recommended that you turn the DVD video camera/
recorder off before inserting or removing disc to prevent 
misoperation.

Do not remove the battery or disconnect the AC adapter/
charger during removal of the disc or until power is 
completely turned off: If you do, the disc cover will not 
open. If this happens, reattach the battery or AC 
adapter/charger, push down the DISC EJECT button 
once, and then release it.

Do not insert anything other than the 8 cm DVD-RAM or 
DVD-R disc into the disc insertion block: Doing so could 
cause malfunctions.

Set the power switch to “POWER OFF” to turn the DVD 
video camera/recorder off.

When inserting or removing the disc, be careful not to 
touch the inside of DVD video camera/recorder 
(especially, the lens of laser pickup (see “Terminology”,  
P. 160)). Also, BE SURE NOT to look into the lens in laser 
pickup: Doing so could damage your eyesight.

DISC EJECT

When grasping the 
holder, avoid the disc 
exposed portion.