Hitachi ed-pj32 User Manual

12

Preparations

Adjusting the projector’s elevator

You can use the elevator feet to make adjustments if the surface on which you 

need to set the projector is uneven or if you otherwise need to adjust the angle of 

projection. The adjustment range of the elevator feet is 0 to 9 degrees.

1.

Press and hold in the elevator buttons while holding the projector. The 

elevator buttons and the elevator feet are on the both sides.

2.

Raise or lower the projector to the desired height and release the elevator 

buttons. When you release the elevator buttons, the elevator feet will lock into 

position.

3.

If necessary, you can also finely adjust the height of the projector by twisting 

the elevator feet by hand.

►Do not adjust the projector’s elevator during use or 

immediately after use. Handling while the projector is in a high temperature  

could cause a burn and/or malfunction to the projector. Before operating, make 

sure that the power switch is off, that the power cord is not plugged in, and that 

the projector is cool adequately.

►If you press the elevator button without holding the projector, 

the projector might crash down, overturn, smash your fingers and possibly  

result in malfunction. To prevent damaging the projector and injuring yourself, 

always hold the projector whenever using the elevator buttons to adjust the 

elevator feet.

►Do not incline the projector rightward or leftward. Also do not incline it 

backward or forward exceeding 9 degrees. Exceeding these range could cause 

malfunction, and could shorten the lifetime of the consumables.

►Except for inclining by the elevator feet adjustment, place the projector 

horizontally.

WARNING

CAUTION

Elevator feet

Elevator button