Delfield ffsc-2 Specification Guide

Delfield reserves the right to make changes in design or specifications without prior notice. ©2002 The Delfield Company. All rights reserved. Printed in U.S.A. 

The exterior sides and top edge shall be 20-gauge galvanized steel. 

Exterior bottom to be 14-gauge galvanized steel.

Inner liner shall be water-tight and constructed of 22-gauge stainless 

steel with a 1.25" (3.2cm) I.P.S. drain. Opening(s) shall have throat liners 

constructed of high impact plastic. Unit to be insulated with foamed-in-place 

polyurethane insulation with a non-conductive top breaker strip. 

Each opening shall have an insulated, stainless steel folding lid with high 

impact plastic liner, molded rubber edge and black plastic handles.

(1) stainless steel louver shall be provided for installation in the cabinet to 

allow proper air flow to the condensing unit.

Each self-leveling mechanism shall be field adjustable by adding or remov-

ing stainless steel extension springs in the elevator housing inside the 

unit. The elevators shall be connected by removable platform carriers 

constructed of 18-gauge stainless steel.

(6) anodized aluminum divider trays will be supplied per opening. NOTE: 

See chart on back for ice cream storage capacity.

Refrigeration system shall use HFC-404A refrigerant. Refrigerant flow 

shall be controlled by an expansion valve. Cabinet shall maintain 0°F to 5°F 

(–18°C to –15°C) temperature with lids closed for storage.

Refrigeration system shall be controlled by a pressure control, located 

near the condensing unit.

Electrical connections shall be 115 volt, 60 cycle, single phase. Unit shall 

have a 9' (2.7m) long electrical cord and NEMA 5-15P installed at the 

mechanical end.

  •   Lid locking device

  •   Wire baskets

  •   *Special voltages (contact factory)

       

*Inclusion of this option will alter the electrical