Delfield nlfac-12 Specification Guide

Delfield reserves the right to make changes in design or specifications without prior notice. ©2002 The Delfield Company. All rights reserved. Printed in U.S.A. 

Exterior Top, Front and Sides shall be 18-gauge stainless steel.  An opening shall be 

located in the top front of the unit to allow access to the interior.  Opening shall have a 

patented “air curtain” design*, with cold air forced over the opening to retain the cold air 

in the interior of the unit.  Opening shall have (2) hinged lids to cover the top and front.  

Two-piece hinged lids shall be molded of black ABS material, with an integral molded 

handle running the full length of each front lid.  Lids shall be seated in a PVC door track.  

Key locks standard (one per door).  Exterior bottom shall be 14-gauge stainless steel.
Interior shall be 22 gauge stainless steel.  Cabinet shall be fully insulated with 2” 

(5.1cm) of high-density foamed-in-place polyurethane. 

Milk crates shall be self-locating in the interior with the use of divider assemblies.  

Divider assemblies shall be 16-gauge stainless steel.  Unit shall have (2) 20-gauge 

stainless steel louvers, which shall be centered left to right on the front and rear of the 

equipment.  A 0.75” (1.9cm) diameter valve shall be located at the bottom of the equip-

ment, centered left to right, 4.75” (12.1cm) from the rear wall.

Refrigeration system shall use HFC-134a refrigerant.  Refrigerant flow shall be con-

trolled by an expansion valve.  Cabinet shall maintain 36˚F to 40˚F (2˚C to 4˚C) interior 

cabinet temperature at 100˚F (38˚C) ambient room temperature with lids closed for 

storage.  Properly chilled food product shall maintain 40˚F (4˚C) for up to 2 hours when 

lids are open.
Refrigeration system shall be controlled by a timer and thermostat.  Control shall be 

accessible through the front louver panel.

Electrical connections shall be 115 volt, 60 Hertz, single phase.  Unit shall have an 8’ 

(2.4cm) long electrical cord and NEMA 5-15 P plug installed at the rear, 14” (30.5cm) 

from the left end, 6” (15.2cm) above floor.

Equipment shall be mounted on (4) 5” (12.7cm) diameter plate casters.

Unit shall hold (8) 13” x 13” x 10.50” (33.0cm x 33.0cm x 26.7cm) milk crates.  

Compressor shall be 1/3 h.p., with condenser coil, (2) evaporator blower coils and 

condensate evaporator.

Unit shall hold (12) 13” x 13” x 10.50” (33.0cm x 33.0cm x 26.7cm) milk crates.  

Compressor shall be 1/2 h.p., with condenser coil, (2) evaporator blower coils and 

condensate evaporator.

Unit shall hold (16) 13” x 13” x 10.50” (33.0cm x 33.0cm x 26.7cm) milk crates.  

Compressor shall be 9/16 h.p., with condenser coil, (2) evaporator blower coils and 

condensate evaporator.

*patented air curtain design.

shown with optional tray slide

Optional accessories and modifications
Tray Slide
Laminate Finish
Fiberglass Panels
220 volt, 50 Hertz electrical system