Delfield ndf-12 Leaflet
PROJECT
ITEM #
QUANTITY
DATE
APPROVAL
The Delfield Company, 980 S. Isabella Rd., Mt. Pleasant, MI 48858, U.S.A. • (800) 733-8821 • Fax (800) 669-0619 • www.delfield.com
Delfield reserves the right to make changes in design or specifications without prior notice. ©2002 The Delfield Company. All rights reserved. Printed in U.S.A.
Short Form Specifications
Exterior sides, front and back shall be 20-gauge stainless steel.
Inner liner shall be water-tight and constructed of 22-gauge stainless steel
Inner liner shall be water-tight and constructed of 22-gauge stainless steel
with a 1.25" (3.2cm) I.P.S. drain. Unit shall be insulated with high-density,
foamed in place polyurethane insulation with a non-conductive top breaker
strip.
Opening shall have stainless steel lift-up and fold-down lids with black
Opening shall have stainless steel lift-up and fold-down lids with black
plastic recessed handles. Door lock is standard.
Ends of the upperstructure shall have die-stamped louvers to allow proper
Ends of the upperstructure shall have die-stamped louvers to allow proper
air flow to the condensing unit.
Refrigeration system shall use HFC-134a refrigerant. Refrigerant flow shall
Refrigeration system shall use HFC-134a refrigerant. Refrigerant flow shall
be controlled by an expansion valve. Cabinet shall maintain 36°F to 40°F
(2°C to 4°C) temperature with lids closed for storage.
Refrigeration system shall be controlled by a pressure control, located
Refrigeration system shall be controlled by a pressure control, located
near the condensing unit.
Electrical connections shall be 115 volt, 60 cycle, single phase. Unit shall
Electrical connections shall be 115 volt, 60 cycle, single phase. Unit shall
have a 9' (2.7m) long electrical cord and NEMA 5-15P plug.
Unit shall be mounted on (4) 4.00" (10.2cm) diameter polyolefin casters
Unit shall be mounted on (4) 4.00" (10.2cm) diameter polyolefin casters
(all locking), and shall have (4) non-marking grey bumpers, one at each
corner.
Optional Accessories and Modifications
• Heavy-duty casters (contact factory)
• Wrap-around bumpers (adds 1.75" [4.4cm] to overall length and
depth)
• Laminate panels
• Fiberglass panels
• Special voltages (contact factory)
Model NDF-18
shown with optional wrap-around bumpers
NOTE: This equipment is intended for storage and /or display of pre-
packaged or bottled products only.
Mobile Drop-Front Self-Contained Milk or Beverage Dispensers
NDF