Amana umc5200ba Installation Instruction

Installation Instructions

Proper installation is the installer’s responsibility!
Write the model & serial numbers on the owner’s
manual. The model number label is located on the oven
front.

UL Listed-For use over electric heat source
models (Wall Ovens)

•  MEW5527, MEW5530, MEW6527, MEW6530
•  AEW3530, AEW4530
•  JJW8527, JJW8530, JJW9527, JJW9530

WARNING

To avoid risk of electrical shock, personal injury,
or death, disconnect power to wall outlet before
beginning installation.

Parts, Tools, and Materials

The following parts are supplied with the oven:

Bracket Base

Trim Frame

Left Bracket

Template 1

Bottom Bracket

template 2

Top Bracket

1” Screw

(1 required, 1 extra)

½” Screw

(14 required, 6 extra)

Tools required to perform installation:

•  Phillips Screwdriver
•  Saw (Electric or Hand)
•  Drill with 7/64” drill bits (Electric or Hand)
•  Tape Measure
•  Pencil
•  Framing Square
•  Level

Shipping Weight

• Approximate shipping weight is 15.7(30”), 14.9(27”)

lbs.

Cutout Dimensions

Dimensions

27”

30”

Height

16 7/8”

Width

25”

Depth (min.)

23 3/4”

��

WARNING

To avoid risk of electrical shock, personal injury, or
death:
• Before drilling into the wall, note where electrical

outlets are and where electrical wire might
be concealed behind the wall.

YOU COULD

GET AN ELECTRICAL SHOCK if you contact
electrical wire with the drill bit.

• Locate and disconnect the power to any

electrical circuits that could be affected
by installing this oven.

IF YOU DO NOT

DISCONNECT THE POWER, YOU COULD GET
AN ELECTRICAL SHOCK.

WARNING

To avoid personal injury, wear gloves when
handling the metal parts. Parts are sharp and can
cause cuts and abrasions.