Viking Range dmoc205 Installation Instruction
Illustration 6
SCREW B
SCREW B
SCREW B
SCREW B
Illustration 9
Illustration 7
Illustration 8
BOTTOM DUCT
ASSEMBLY
FOOT
DUCT RECESS
NOTE: CENTER BOTTOM DUCT
ASSEMBLY iN ThE OpENiNg
SCREW
BOTTOM
DUCT
ASSEMBLY
DETAiL A
SCREW C
gAp "A"
gAp "B"
3
MOUNTING TEMPLATE
1. Align the mounting template center line with the center
of the cutout and the floor line with the floor of the
cutout. Tape it into place.
. For DMTK76, only predrill 4 holes marked “A” with
a 1/16" drill bit. For DMTK306, only predrill 4 holes
marked “B” with a 1/16" drill bit.
3. Remove template from the cabinet.
BOTTOM DUCT ASSEMBLY
1. Place the Bottom duct in the center of the opening so
that gap "A" is equal to gap "B". When the BOTTOM
DUCT ASSEMBLy is in the opening correctly, the
bottom flange will fit tightly against the lower edge of
the opening. See illustration 6.
. Secure the BOTTOM DUCT ASSEMBLy with the two
(3/4") SCREWS (C). IMPORTANT: Secure screws using
holes on bottom flange.
CABINET INSTALLATION
1. Place the oven adjacent to the wall or cabinet opening.
Plug the power cord into the electrical outlet.
. Carefully guide the assembled oven into the prepared
opening. Slide the oven on the BOTTOM DUCT
ASSEMBLy. See illustration 7. Avoid pinching the cord
between the oven and the wall. Adjust the position
of the oven so that the feet of the oven are fitted into
the holes of the BOTTOM DUCT ASSEMBLy. See
illustration 8.
FRAME INSTALLATION
Position the BACK FRAME to align with the predrilled
holes that were drilled with the mounting template. Check
that it is level and then secure with two SCREWS (B). See
illustration 9. Secure the bottom portion of the BACK
FRAME with the two remaining SCREWS (B).