Delta Electronics d3355 User Guide
M
AINTENANCE AND
S
ECURITY
Replacing the Projection Lamp
The projection lamp should be replaced when it burns out. It should only be replaced with a certified
replacement part, which you can order from your local dealer.
replacement part, which you can order from your local dealer.
Important:
1.
The lamp contains a certain amount of mercury and should be disposed of according to local
ordinance regulations.
2.
Avoid touching the glass surface of the new lamp: Doing so may shorten its operation life.
Warning:
Be sure to turn off and unplug the projector at least an hour before replacing the lamp. Failure to do
so could result in a severe burn.
so could result in a severe burn.
1.
Loosen the captive screws on the
lamp compartment cover (A).
lamp compartment cover (A).
2.
Remove the lamp compartment
cover (B).
cover (B).
A
A
B
3.
Loosen the two captive screws from
the lamp module (A) you are
replacing.
the lamp module (A) you are
replacing.
4.
Lift the module handle up (B).
A
A
A
A
B
B