Ricoh BP20 User Guide
Administratior Guide
Page 3-7
Ne
twork
Ins
tal
la
tio
n Us
in
g In
ternet
Se
rv
ic
es
TCP/IP
Use these instructions to install the device on a TCP/IP network using Web Aficio BP20N.
Installation Procedure
There are two stages required to install the device on a TCP/IP network using Web Aficio
BP20N:
BP20N:
¾
Configure the Aficio BP20N
This procedure explains how to use Web
Aficio BP20N
to configure the
device.
¾
Test Print
A print job should be submitted to ensure the device has been installed and
configured correctly.
configured correctly.
Configure the Aficio BP20N
NOTE: The TCP/IP settings for the device will have been set up when completing
the Enabling Web Aficio BP20N section.
the Enabling Web Aficio BP20N section.
To complete the installation of the device, perform these steps:
¾
Enable Web Aficio BP20N (see “Enabling Internet Services” on page 3-5).
¾
At the Web Aficio BP20N Home Page for the Aficio BP20N, select the [Network
Administrator] tab.
Administrator] tab.
¾
Click TCP/IP menu in the left frame.
¾
Check if the TCP/IP Configuration details are correct. If any of the details are incorrect
then enter the correct information.
then enter the correct information.
Choose the [IP Address Assignment Method] required.
NOTE: DHCP automatically assigns IP addresses and is the default setting. If the
IP Address needs to be edited but is unavailable, select IP Address Assignment
Method and then Static to continue.
IP Address needs to be edited but is unavailable, select IP Address Assignment
Method and then Static to continue.
Enter the [IP Address].
1
2
3
4
2
3
4