Haier xqg50-qf800 User Manual
13
4
Trouble shooting
Installation
Fig 1
Adjusting the position of the washing machine .There are ad-
justable feet under the bottom of the washing machine. Before use,
the washing machine should be adjusted, as shown in figure 3, so
that it is level.
As shown in figure1 remove all the packing materials
(including the foam base).
Check attachments and materials.
Remove the packing screws as shown in figure 2.
The packing bolts protect the appliance from shock during trans-
portation The steps betow should be followed before using the
appliance,
1. Remove the rear panel of the washing machine;
2. remove the three packing bolts from the rear panel of the wash-
ing machine,the rubber hose and then the shock absorption chan-
nel steel;
3. reinstall the back plate;
4. fill the holes left by the packing bolts with plastic plugs.
(Attention: the packing bolts and rubber hose should be kept in a
safe place for later use)
portation The steps betow should be followed before using the
appliance,
1. Remove the rear panel of the washing machine;
2. remove the three packing bolts from the rear panel of the wash-
ing machine,the rubber hose and then the shock absorption chan-
nel steel;
3. reinstall the back plate;
4. fill the holes left by the packing bolts with plastic plugs.
(Attention: the packing bolts and rubber hose should be kept in a
safe place for later use)
Name
Qu'ty
Model
XQG50-
QF800TX(SS)
Operational
manual
Quality
certificate
Water
hose
Drainage
holder
Plastic
plugs
Distributor
box
1
1
1
1
1
3
The detergent is not a Iow foam type
Excessive detergent has been used
The following circumstances do not constitute problems. De net contact
the maintenance service until the problem has been confirmed.
Problem
The washing machine fails to
operate
Washing machine does not fill
with water
The water supply and
drainage do not stop
Drainage failure
Strong vibration during spin
O p e r a t i o n s t o p s
b e f o r e
completion of the wash cycle
Excessive foam in the drum
Possible Cause
Poor connection to power supply
Power failure
Door is not properly closed
Machine has not been switched on
Water is not turned on
Water pressure is less than 0.05MPa
The inlet hose is kinked
Water supply failure
The program knob is not properly set
The door is net properly closed
Check that the height of the water hose is below
80cm
Drainage hose is blocked
Drainage hose end is below 100cm above the
floor level
Some packing fixing bolts removed
Washing machine on a uneven surface
Water or electricity failure
Fig 2
Fig 3