Frigidaire faa065m7a1 Installation Instruction
Drive 3/4 (19 mm) locking screws
through frame holes and into sill
(FIG. 8).
through frame holes and into sill
(FIG. 8).
NOTE: To prevent window
sill from possible splitting, drill 1/8 (3 mm)
pilot holes before driving screws.
pilot holes before driving screws.
Drive 1/2
(13 mm)
locking
screws
(13 mm)
locking
screws
through frame holes
into window sash
(FIG. 9).
into window sash
(FIG. 9).
To secure lower sash in place, attach
right
angle safety lock onto side frame of top
window
right
angle safety lock onto side frame of top
window
with 3/4 (19 mm)
screw as shown
(FIG. 10).
screw as shown
(FIG. 10).
Cut foam sash seal to window width and
place into space between upper and
lower sashes to seal out air infiltration
(FIG. 11).
place into space between upper and
lower sashes to seal out air infiltration
(FIG. 11).
3
4
5
FIG. 10
FIG. 8
FIG. 11
If AC is Blocked by Storm
Window
Window
Add wood as shown in FIG. 12, or remove storm
window before air conditioner is installed.
window before air conditioner is installed.
If Storm Window Frame must remain, be sure
the drain holes or slots are not caulked or
painted shut. Accumulated Rain Water or
Condensation must be allowed to drain out.
the drain holes or slots are not caulked or
painted shut. Accumulated Rain Water or
Condensation must be allowed to drain out.
Removing AC From
Window
Window
*
Turn AC off, and disconnect power cord.
*
Remove sash seal from between windows,
and unscrew safety locks.
and unscrew safety locks.
*
Remove screws installed through AC frame.
*
Close (slide) side panels into frame.
*
Keeping a firm grip on air conditioner, raise
sash and carefully rock air conditioner
backward to drain any condensate water in
base of unit. Be careful not to spill any
remaining water while lifting unit from
window. Store parts WITH air conditioner.
sash and carefully rock air conditioner
backward to drain any condensate water in
base of unit. Be careful not to spill any
remaining water while lifting unit from
window. Store parts WITH air conditioner.
FIG. 9
6
7
SASH
1 1/2” MIN
(38 mm)
STORM WINDOW
FRAME
OR OTHER
OBSTRUCTION
FRAME
OR OTHER
OBSTRUCTION
BOARD
THICKNESS
AS REQUIRED,
FOR PROPER
PITCH TO
REAR, ALONG
ENTIRE SILL.
FASTEN WITH
TWO NAILS OR
SCREWS.
THICKNESS
AS REQUIRED,
FOR PROPER
PITCH TO
REAR, ALONG
ENTIRE SILL.
FASTEN WITH
TWO NAILS OR
SCREWS.
FIG. 12