Scitec 205t User Manual

 

This package should contain the following: 

The 205T telephone is designed for use behind a registered PBX 
system.  The telephone user or system installer must supply an RJ-11 
modular wall jack to connect this telephone to the PBX system.  The 
PBX “station port” type must be “Industry Standard Analog” or “POTS.”  
This telephone cannot be used with “digital” PBX station ports.    

•  Telephone base unit 

•  Telephone handset unit 

•  Coiled handset cord 

•  Straight line cord 

 

•  5 inch straight line cord 

Insert one end of the coiled handset cord into the jack on the BOTTOM 
END of the base unit. Insert the other end of the cord into the jack on 
the BOTTOM END of the handset. The handset of the unit should now 
be placed into the base of the unit.  Connect the straight line cord from 
the wall jack to the line jack located underneath the base unit.  

 
 
 
 

 

 Lift the handset.  A dial tone should be heard in the receiver.   

 

 

 

 

Connect the base unit to the handset as instructed above.  Connect the 
5 inch straight line cord from the wall jack to the line jack located 
underneath the base unit.  Align the slotted holes on the back of the 
telephone over the mounting studs on the wall jack.  Pull down on the 
telephone until the studs are locked in place.