Scitec 2554w User Manual

This package should contain the following: 
 

•  Telephone wall unit 

•  Handset 

•  Coiled handset cord 
 
 
 
 
 

 
The 2554W telephone is designed for use behind a registered PBX 
system.  The telephone user or system installer must supply an RJ-11W 
modular wall jack to connect this telephone to the PBX system.  The 
PBX “station port” type must be “Industry Standard Analog” or “POTS.”  
This telephone cannot be used with “digital” PBX station ports.    
 
Insert one end of the coiled handset cord into the jack on the BOTTOM 
SIDE of the base unit. Insert the other end of the cord into the jack on 
the bottom end of the handset.  
 
Fit the plug on the back of the telephone into the wall jack.  Align the 
slotted holes on the back of the telephone over the mounting studs on 
the wall jack.  Pull down them on the telephone until the studs are 
locked in place.  Lift the handset.  A dial tone should be heard in the 
receiver.   
 
 
 
 
 
 
 

 
 
Hearing-aid Compatible Handset 
 
VOL switch – Volume control switch on the handset steps through the 

three available handset volume levels [Normal – Medium – 
High]. 

 
Handset Jack – Modular jack to connect coiled handset cord from 

handset to telephone. 

 
Dialing Keys – 0 – 9 dialing keys. 
 
 
 
 

To place a call:  Lift the handset, then dial the number desired. 
 
To answer a call:  Lift the handset. 
 

The volume control switch is located on the handset.  As the switch is 
moved toward top of the handset, the volume level will increase through 
the volume settings of  <normal – medium – high>.  The volume will 
decrease as the switch is moved toward the bottom of the handset.  
Adjust as desired.