Scitec h2001 User Manual

 
The H2001 telephone is designed for use behind a registered PBX 
system.  The telephone user or system installer must supply an RJ-11 
modular wall jack to connect this telephone to the PBX system.  The 
PBX “station port” type must be “Industry Standard Analog” or “POTS.”  
This telephone cannot be used with “digital” PBX station ports.    

 
This package should contain the following: 
 

•  H2001 telephone 

•  Straight line cord 

  

•  Clip (for attaching telephone to a bed rail) 

Connect the straight line cord from the wall jack to the line jack located 
on the bottom end of the telephone. Press the [PUSH FOR ON-OFF], 
and a dial tone should be heard.  

 

 

 
Placing a call — Press the [PUSH FOR ON-OFF] key, then dial  
  number 

as 

desired. 

 
Taking a call  — Press the [PUSH FOR ON-OFF] key. 
 
Adjusting phone volume  — Press the [VOL] key, each press steps 
 

 

through the volume settings of [Low – Medium –  

 

 

High – Low]. Adjust as desired. 

 
Ringer volume control — Slide the [Off-Low-Hi] volume switch to 
 

 

adjust ringer volume.  In all ringer modes, ringing will 

 

 

be accompanied by a flashing light on the telephone. 

 
Flash Key — Enters a 600ms hook switch flash for accessing special 

telephone system features. 

 
Lighted Keypad –  0–9, *, and # dialing keys are Illuminated for low 

light conditions. 

 
LED indicator — Indicator is red when telephone is ringing.  When the 

telephone is in use, the indicator is green.