Frigidaire fdr251rjs0 Operating Guide

11

The portable/convertible dishwasher must be connected to a faucet and electrical outlet each time it is used.
Follow directions on this page to properly connect dishwasher.

IMPORTANT: Make sure door is latched before moving dishwasher.
The power cord, faucet coupler and hoses are located in a compartment in
back of dishwasher. A special adapter must be installed on faucet before you
can connect dishwasher (Figure A).
1.  Remove faucet adapter assembly from literature package.
2.  Unscrew existing sink faucet aerator.
3.  Check faucet spout to see if threads are inside or outside.

• If threads are on 

inside

 of faucet spout, use both thick and thin rubber

washers.

• If threads are on 

outside

 of faucet spout, use thin rubber washer only.

• If faucet has no threads, an adapter kit with instructions for attachment to

a non-threaded spout is available at most hardware stores.

4.  Assemble faucet spout as shown in Figure A. Make sure the two brass

screens are located below the rubber washers.

1. Run water at faucet until it is hot. Turn off faucet.
2. Pull hoses out of compartment.
3. Push collar down and slip faucet connector onto faucet adapter (Figure B).
4. When connector snaps into place, release collar.
5. Slowly turn on hot water all the way.
6. Plug power cord into grounded outlet.

1. When cycle has finished, turn off hot water.
2. Press red button on coupler to release water pressure.
3. Press down on collar to release coupler.
4. Empty remaining water from coupler and return it to compartment.
5. Unplug power cord and return it to compartment.

IMPORTANT:  A sink spray hose can burst due to constant water
pressure while in use. If your spray hose is installed on same water line
as the dishwasher, it is your responsibility to disconnect sink's spray
hose and to plug hole.

An electrical supply of 120 volts, 60 Hz, AC only, 15 amps is required. For
your safety, the dishwasher must be grounded. If there is a malfunction or
breakdown, grounding will reduce risk of electrical shock. This dishwasher has
a power cord with a 3-prong grounding plug. It must be plugged into a mating
3-prong grounding type receptacle, installed and grounded in accordance with
the National Electrical Code and any local codes and ordinances.

Avoid fire hazard or electrical shock.  Do not
use an adapter plug, extension cord or remove
grounding prong from electrical power cord.

Failure to follow this warning can cause
serious injury, fire or death.